Series 73 Coaxial Probes are designed for low level signal probing to less than 10fA. The probe's single unit design is especially desirable for the best possible electrical characteristics; however, in applications that can tolerate slightly higher noise levels, APT's 74J/X series of probe holders with replaceable points achieve similar results. The Series 73 Coaxial Probe is also offered with optional Ground Plane, Kelvin and resister series /parallel configurations. Contact APT for further specifications available for your particular application

The Model 73 Series Probes are constructed of microwave-quality components. The 50 Ohm semi-rigid cable consists of 8 mil tungsten wire forming the inner conductor and probe point, with isolation from the gold plated copper shield being achieved through the utilization a Teflon dielectric. The probe contact protrudes from the shielding by .150" to maintain low level signal noise to the probe. Probe point radii are electrochemically etched to 5µm or point size may be specified by the user. The connector is an industry standard SSMC, mounted in a brass mounting shank where it is attached to the coax.

The 73 Coaxial Probe can be ordered in various mounting configurations to allow compatibility with all major manufacturer's brands of micropositioners and/or probe holders. Please specify micropositioners and test station being used; APT can recommend the proper configuration for your requirements.

To complete your probing configuration, APT recommends the Model 76CPC-SSMC Coaxial Cable. This RG# 178B/U cable has a characteristic impedance of 50 ohms, 29 pf/ft, attenuation of 0.29 db/ft at 400 MHz. The dielectric is Teflon. A high frequency sub miniature SSMC connector attaches to any of APT's coaxial probes or SSMC equipped probe holders, and a BNC connector terminates the cable.